MUTOH Rockhopper II Series Especificações descarregar pdf (Página 193)

Rockhopper II series printers – Maintenance Manual

194

AP-74065, Rev. 1.2, 27/09/04

5.9.9. General Endurance Menu

This menu performs the general endurance running.

You can operate various driving systems according to your desired settings.

The available settings are shown below.

Setup item Description Parameters Remarks

Operation speed (CW,

CCW)

Sets carriage operation speed (CW

and CCW).

240/300 Unit: cps

Media feed amount Set the media feed amount per cycle 0 to 100 Unit: mm

Number of endurance

running cycles

Set the number of endurance running

cycles

-1 to 10000

Notes :

¾ If the number of endurance running cycles is set to -1, the units continuously repeat

endurance running until a key input is given from the operation panel.

¾ The maximum counter value for endurance running cycles is 99999999 (up to 8-digit

number). If the number of cycles exceeds the maximum value, the counter is reset to 0.

* Speed CW *

Speed 240 / 300 + Speed (CW)

240 cps -

↓ ENTER

* Speed CCW *

Speed 240 / 300 + Speed (CCW)

240 cps -

↓ ENTER

* Feed Amount *

0 – 100.0 mm + Media feed amount

0.1 mm -

↓ ENTER

* Life Count *

Count

-1 → 10000 +

Number of total endurance running cycles

50 -

↓ ENTER

* Total Life *

Count 5 Perform endurance running

↓ ENTER or CANCEL

* Total Life *

End 50

1 2 ... 188 189 190 191 192 193 194 195 196 197 198 ... 318 319

Comentários a estes Manuais

Sem comentários

MUTOH Rockhopper II Series Especificações Página 193

Comentários a estes Manuais

Manuais e produtos relacionados com Digitalizar e Imprimir MUTOH Rockhopper II Series