MUTOH Rockhopper II Series Especificações descarregar pdf (Página 220)

Rockhopper II series printers – Maintenance Manual

221

AP-74065, Rev. 1.2, 27/09/04

7.7. HEAD PRECISION ADJUSTMENT (SLANT)

This section explains the procedure for adjusting the head angle.

When replacing the head assembly, use the following procedure to adjust the head angle and head

forward/rear position.

7.7.1 Head slant adjustment

7.7.1.1 For a 4 head machine

Step 1 : Start the self-diagnostic function.

Notes :

¾ Refer to “Self-Diagnosis Function”

Step 2 : Select "Adj:HeadSlant".

Step 3 : Print "Slant" pattern.

If dotted lines on pattern CW and CCW are not a straight line, which you can check with a

magnifying glass (enlargement of at least 10), please go to step 4.

Notes :

When the printing pattern is printed, you will only see lines, and no notifications of ink

channels. The head sequence shown below.

4 head model: 1A, 1B, 2A, 2B, 3A, 3B, 4A, 4B

Step 4 : Loosen the screw (with one turn) fixing the head stationary plate.

Step 5 : Make adjustments until amount of CW and CCW offset are identical.

No. Part

1 Screw (M2.5x5) fixing the head stationary plate

2 Angle adjustment screw

3 Front and back adjustment screw

1 2 ... 215 216 217 218 219 220 221 222 223 224 225 ... 318 319

Sem comentários

MUTOH Rockhopper II Series Especificações Página 220